DivideiT is assembled with a joiner in the middle.

Click here - YouTube link for detailed attachement options

Parts

DivideiT parts

Fixings

DivideiT Fixings

Panel Storage 3

View of Divideit panel in storage

Parts

DivideiT parts

1/11

1

On one side of the Panel (A) place Bracket (D) into position and secure with the screw provided. On other side of the Panel (A) repeat as for the previous side.

2

Check underneath ute tray to ensure the screws will not penetrate anything except the tray floor. For steel floors you may need to predrill holes with a 3mm drill bit. Place A, D assembly next to the side panel of the tray equal distance from the headboard and screw into floor with the screws supplied. 315mm is a good distance from the headboard for shopping bags.

3

Locate Joiner (B) over Panel (A) equal distance from each side of the ute tray.

4

Fix Joiner (B) in place at the marked locations with the screws provided.

5

Remove the screw in Bracket (D) and Panel (A) and replace with the minsup clip provided for the removable option.

6

Screw End Cap (C) in place on the tray side panel close to the headboard to create a storage slot for the divider when not in use.

Safety & Other Instructions

1 / Follow Safety Guidelines:

Ensure all loads, cargo, goods, attachments, and aftermarket products, including DivideiT, are fixed, secured, and covered according to the applicable laws and regulations of the area that it is being used in. Click to follow link to Load Restraint Guide

2 / Driver Responsibility:

The driver of the vehicle is responsible for ensuring at the time of operation of the vehicle that DivideiT is installed and used correctly with the supplied brackets.

Registered Design 202418410

30 DAY MONEY BACK GUARANTEE*

DivideiT is assembled with a joiner in the middle.

Click here - YouTube link for detailed attachement options

1

On one side of the Panel (A) place Bracket (D) into position and secure with the screw provided. On other side of the Panel (A) repeat as for the previous side.

2

3

Locate Joiner (B) over Panel (A) equal distance from each side of the ute tray.

4

Fix Joiner (B) in place at the marked locations with the screws provided.

5

Remove the screw in Bracket (D) and Panel (A) and replace with the minsup clip provided for the removable option.

6

Screw End Cap (C) in place on the tray side panel close to the headboard to create a storage slot for the divider when not in use.

Safety & Other Instructions

1 / Follow Safety Guidelines:

Ensure all loads, cargo, goods, attachments, and aftermarket products, including DivideiT, are fixed, secured, and covered according to the applicable laws and regulations of the area that it is being used in. Click to follow link to Load Restraint Guide

2 / Driver Responsibility:

The driver of the vehicle is responsible for ensuring at the time of operation of the vehicle that DivideiT is installed and used correctly with the supplied brackets.

3 / Warranty:

The warranty only applies to correctly installed and the correct use of DivideiT.

4 / Cleaning:

Use a commercially available car or truck wash cleaning product and follow the cleaning product instructions for use. Spot/stain clean with CRC.